73
Meridian 1
Content protection:
¾
According to High-Definition Content Protection (HDCP) Specification 1.10
y
Common
Interface
Complies with version 1: EN50221 ETSI TS 101 699, V1.1.1 (1991-11) and [R206-001F] (DTV
only)
y
No Signal
Input
While no signal at external inputs, screen goes blue before entering standby mode.
3.3.1.1 HDMI CEC
Compliant with HDMI Ver.1.3a CEC
y
One-Touch-Play
Device can switch on the television (when in standby) and switch to the relevant
HDMI source. Allows a device to be played and become the active source with a
single button press.
y
Routing Control
This feature is used to control the routing of the HDMI network, by controlling
CEC Switches. In general whenever a device starts being streamed to the TV
y
System Standby
Enables the user to switch all devices to standby with one button press
y
System Information
Allow devices to automatically use the same OSD and Menu language settings
as the TV and also for a TV to discover the current language when it is being
installed.
y
Give Device Power Status
The message is used to determine the current power status of a target device.
The target device responds with a message containing the Power Status
operand.
3.3.2 Audio Signal Requirements
y
Audio input -
Sensitivity 500mVrms, the amplifier outputs full power when the input level
reaches 500mVrms, terminated with input impedance of >10k
Ω
.
y
Headphone output
N.A.
y
Amplifier output
2 x 3Wrms, with T.H.D. < 10%
y
SPDIF output
Carrying stereo or multi-channel output (DTV tuner digital audio or HDMI digital
audio loop through)
3.3.3 PC Signal Requirements
y
Pixel rate capability
160 MHz for ATV, 160 MHz for DTV
y
Sync input
TTL level, separate H / V sync only, “+” or “-“ polarity, terminated with
≥
2.2k
Ω
impedance
y
Horizontal frequency
30 ~ 83 KHz
y
Vertical frequency
56 ~ 76 Hz
y
PC analog RGB level
0 ~ 700 mV linear, positive polarity, terminated with 75
Ω
impedance
y
I
2
C DDC signal
DDC serial Data & Clock, DDC components are connected to both monitor Vcc
and DDC +5V (from PC via video cable), that the PC can read the DDC data
also when the monitor is powered off. To prevent current feedback into PC,
blocking diodes are required at monitor side.
y
Preset video timings
Follow VESA timing mode up to panel native resolution. Preset video timings,
