更多难得资料请到江南家电维修论坛免费下载！
http://bbs.520101.com
characteristics
5.1 Cosmetic
Philips ID
5.2 Mechanical data files
ProE files required
5.3 Location of Philips Logo
Per Philips make-up sheet
5.4 Gap between panel and front bezel
< 1.4mm (typ.)
5.5 Location of Control Icons
Per Philips Graphic sheet
5.6 Color for resin/paint
Per Philips make-up sheet
5.7 Resins
•
RoHS required
•
WEEE required.
•
Resin type/selection refers to Project Book Section 7.2 Plastic material.
5.8 If paint is used
•
RoHS required
•
WEEE require
•
If new painting type needs to implement, refer to UN-D 1235.
5.9 Plastic mold tooling
•
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Refer to “TYV61-90007”.
•
Painting to cover up cosmetic defects due to molding is strongly discouraged.
•
China RoHS mark requested.
5.10 Plastics flammability
•
All Plastics to be Flame Retardant UL 94-HB.
•
Base / Rear to be Flame Retardant UL 94-HB
•
All major plastic parts (bezel, back cover) need to be molded from same resin. Plastic resin type selection
should be referred to “TY R83-2-9002-1”.
5.11 Texture/Glossing of housing
•
The texture area and texture no should follow Philips make-up sheet.
•
The exterior surfaces shall have a uniform texture.
•
Philips must approve the mold texturing.
•
Detail document for texture refer to “UN-D249”, “UN-D 600”.
•
> = 80 gloss units
