Philips 170C7FS/00, Service Manual

Page: 12 / 84

12
Go to cover page
170C7 LCD
Lock/Unlock,Aging,Factory Mode
Front Control
To Lock/Unlock OSD FUNCTION(User Mode)
The OSD function can be locked by pressing"OK"button(1) for more
than 10 seconds, the screen shows following windows for 4 seconds.
Everytime when you press"OK" button, this message
appears on the screen automatically.
ATTENTION SIGNAL
OSD MAIN CONTROLS
LOCKED
Unlock OSD function
Unlocked OSD function can be released by pressing "OK" button for
more than 10 seconds again.
ATTENTION SIGNAL
OSD MAIN CONTROLS
UNLOCKED
After 15 seconds,
bring up:
----------
----------
repeatly
Connect Signal cable again=> go back to normal display
After 15 seconds,
bring up:
After 30 seconds,
bring up:
AGING...
Access Aging Mode
Step 1 : D
Step 2 :
[Push "AUTO" & " OK " buttons
at the same time and hold them]+[Press power " " button untill comes
out " AGING screen"] => then release all buttons.
Bring up:
isconnect Interface Cable between Monitor and PC.
Turn off LCD monitor.Then
AGING...
Access Factory Mode
1). Turn off monitor.
2).
3).Press "OK" button, wait until the OSD menu with Characters
"HUDSON 170C7 V010 2006/06/29" (below OSD menu) come
on the Screen of the monitor.
[Push "AUTO" & "OK" buttons at the same time and hold them]
+[Press "power" button untill comes out "Windows screen" ]
=> then release all buttons
Factory Mode indicator
Factory Menu
Cursor can move on gray color area
Hot key function: by pressing " UP " and " DOWN " key
Simultaneously at User Mode (or Factory Mode)
(PS: The Offset R G B function can be used on reduce or eliminate
snowy noise on the background when the resolution of video signal
is 1280*1024 vertical 60Hz. Slightly increase or decrease the value
until snowy noise completely disappear.
SUB-BRI : Brightness value range(Min Max)
SUB-CON : Contrast value range(Min Mid Max)
SRGB-B : Brightness of sRGB
SRGB-C : Contrast of sRGB
Gain-m : Minimum value of User Gain
Gain-M : Maximum value of User Gain
AUTO-SUB : To do Auto color function when push Menu key
in white pattern
IDX : Limit current of inverter
SCALER : Read/Write scaler register
NVRAM : Read/Write eeprom address
Panel : HS, LG, AU, QDI, DEFAULT?.
EXIT : Exit Factory Menu
SAVE : Save the setup values of Factory Menu