Philips AVENT SCD530 - Avent DECT Baby Monitor Monitoring System, User Manual

Page: 18 / 256

Question Answer
The baby unit and the parent unit may be out of range of each other.
Move the parent unit closer to the baby unit, but not closer than 1
metre/3 feet.
If the LINK light on the parent unit still does not start to flash, use the
reset function to reset the units to their default settings.
Why does the LINK light
on the parent unit light
up red continuously and
why is the message
‘Not Linked’ shown on
the display?
The baby unit and the parent unit are out of range of each other.
Move the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
Why does the battery
symbol flash on the
display of the baby unit?
The non-rechargeable batteries of the baby unit are running low.
Replace the non-rechargeable batteries or connect the baby unit to
the mains (see chapter ‘Preparing for use’).
Why does the parent
unit beep?
If the parent unit beeps while the LINK light lights up red continuously
and the message ‘Not Linked’ is shown on the display, the connection
with the baby unit is lost. Move the parent unit closer to the baby unit.
If the parent unit beeps and the battery symbol on the display is
empty, the rechargeable battery pack of the parent unit is running low.
Recharge the rechargeable battery pack.
If you have switched off the volume while the sound alert is on, the
parent unit beeps whenever the fourth sound level light lights
up because the baby unit has picked up a sound.
If you have set the room temperature range on the parent unit and
the temperature alert is on, the parent unit beeps when the
temperature drops below the set level or below 14°C or when the
temperature rises above the set level or above 30°C.
The baby unit may be switched off. Switch on the baby unit.
Why does the appliance
produce a high-pitched
noise?
The units may be too close to each other. Make sure the parent unit
and the baby unit are at least 1 metre/3 feet away from each other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
Why don’t I hear a
sound/Why can’t I hear
my baby cry?
The volume of the parent unit may be set too low or may be
switched off. Increase the volume of the parent unit.
The microphone sensitivity level of the baby unit may be set too low.
Set the microphone sensitivity level to a higher level in the menu of
the parent unit.
The baby unit and the parent unit may be out of range of each other.
Reduce the distance between the units.
EngliSh
18