Philip Laurence Auto chronograph, Manual

Page: 9 / 64

Manuals for Philip Laurence watches
9
to ensure that your chronograph operates with perfect precision for many years to come,
we advise you to pay very careful attention to the advice provided hereafter.
uSAGE / SEttinGS
MOdELs wITH A sCREwEd CROwN
to ensure that they remain water-resistant, some models are fitted with a screwed crown.
Before proceeding to setting the time or date, you must first unscrew the crown into
position IB before pulling it out into position II or III.
Important: After each operation, you must always screw the crown back down to
ensure that your watch remains water-resistant.
sETTINg THE TIME
pull the crown out to position III and turn it clockwise or counterclockwise to set the
desired time. Synchronize the small seconds-hand, located at 6 o’clock, to an official time
signal (radio/tV/ internet) by pulling out the crown to its second stop; the seconds hand stops
at this point. As soon as the time setting has been synchronized, push the crown back down
into position
I
(and tighten it back down on models with a screwed crown).
wINdINg
Quartz chronographs never need to be wind.
RAPId CORRECTION OF THE dATE
pull the crown out into position II and turn it forwards until the correct date is displayed.
During this operation, only the hour hand rotates.
SEttinG tHE countErS to zEro
the counters must be zeroed before chronograph mode is
initiated. if necessary, proceed as follows:
zero the 60 seconds counter hand (crown in position III ,
pusher
A
)
zero the 30 minutes (or 12 hours) counter hand (crown in
position
II
, pusher
B
)
zero the 1/1 oth of a second counter hand (crown in position
III , pusher B )
passport_20_10_2009.indd 9 20.10.2009 20:52:43