Philio PSM09-A, User Manual

Page: 2 / 7

Troubleshooting
Symptom Cause of Failure Recommendation
The device can not
join to Z-Wave™
network
The device may in a Z-
Wave™ network. Exclude the device
then include again.
For Instruction to http:// www.philio-tech.com
Add to/Remove from Z-Wave TM Network
There are one tamper key in the device,the key is in the front side. Both of
them can add, remove, reset or association from Z-Wave
TM network.
SmartStart enabled products can be added into a Z-Wave network by scanning
the Zwave QR Code present on the product providing SmartStart inclusion. No
further action is required and the SmartStart product will be added
automatically within 10 minutes of minutes On in the network vicinity
Notice : Including a node ID allocated by Z-Wave TM Controller means “ Add ” or
“ Inclusion ”. Excluding a node ID allocated by Z-Wave TM Controller means
“ Remove ” or “ Exclusion ”.
Function
Description
Add
1.
Have Z-Wave TM Controller entered inclusion mode.
Pressing tamper key three times within 3 seconds to
enter the inclusion mode.
If the learning code is successful, the LED will flash
slowly.
Remove
1.
Have Z-Wave TM Controller entered exclusion mode.
Pressing tamper key three times within 3 seconds to
enter the exclusion mode.
If the removal is successful, the code light will flash for
30 seconds.
Node ID has been excluded.
Reset
Notice: Use this procedure only in the event that the
primary controller is lost or otherwise inoperable.
1.
In 3 seconds, press the button 3 times continuously,
after 3 successful, then slowly flash for 1 second, press
the fourth button, do not release the button, the LED
will light up, after about three seconds, the LED will off,
and in two seconds Release the button internally. If the
clearing is successful, the LED will flash slowly. If it fails,
the LED will flash quickly.
2