06-10-2020 15
:
11
Pagina 3 van 9
http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1C
Replace the new battery and install the cover back.
Put the front cover bottom to 1-1, and press down.
Push the front cover top to 2-1.
Choosing a Suitable Location
The recommended mounting height is 160cm
Don"t let the device facing the window or the sunlight.
Don"t let the device facing the source of heat. For instance the heater or the air-condition.
Installation
In the first time, add the device into the Z-WaveTM network. First, make sure the primary controller is in the inclusion mode. And then power on the devi
take out the insulation Mylar in the back side of the device. The device will auto start the NWI (Network Wide Inclusion) mode. And it should be included
seconds. You will see the LED light ON one second.
Let the controller associate with the device into the first group, any light switch that intend to be turned on when the device trig please associate with the
into the second group.
In the accessory pack. There are two type of double coated tape, one is thicker (hereinafter referred to as A tape) and another is thinner (hereinafter refe
as B tape), you can use A tape for the test at the beginning. The right way for A tape installation is stick it to the position below tamper key. The thicker ta
