3
Product Overview
For Instruction to http://
www.philio-tech.com
Adding to Z- Wave
TM
Network
In the front casing, there is an on/off button with LED indicator below which is used to
switch on and off, dim level, or carries out add, remove, reset or association.
When first power is applied, its LED flashes on and off alternately and repeatedly at
0.5 second intervals. It implies that it has not been assigned a node ID and start auto
inclusion.
Auto Inclusion
The function of auto inclusion will be executed as long as the dimmer does not
have Node ID and just connect the dimmer to main power.
Note: Auto inclusion timeout is 2 minute during which the node information of explorer
frame will be emitted once every several seconds. Unlike “inclusion” function as
shown in the table below, the execution of auto inclusion is free from pressing the
On/Off button on the dimmer.
The table below lists an operation summary of basic Z-Wave functions. Please refer
to the instructions for your Z- Wave
TM
certificated primary controller to access the
setup function, and to Add/Remove/Associate devices
Function
Description
Annotation
No node ID
The Z-Wave Controller does not allocate
a node ID to the Switch.
LED 2-second on, 2-second
off
Add
(Inclusion)
1.
Put your Z-Wave controller into
inclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing Include button of PAD02
three times within 2 seconds will
enter inclusion mode.
Remove
(Exclusion)
1.
Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
On/off Button, Learn key and
Dimmer key (dimmer on status)
