PSR07 Smart Color Button
This device is a multiple functions button switch. It is able to
switch the appliances on/off or adjust the percentage of dimmer.
It can also work as a timer. The well designed wall bracket and
magnetic back let the switch can be fixed on the wall. This product
can be included and operated in any Z-Wave
TM
network with other
Z-Wave
TM
certified devices from other manufacturers and/or other
applications.
Note:
Please provide a 5 DVC voltage through Micro USB Port to
wake the device up before the first using.
The rotation function and timer functions work only when the
device is fitted upright or stick on the wall or the device will only
work as an on/off switch when fitted horizontal.
Z-Wave Network Setting Up
In the first time, add the device into the Z-Wave
TM
network. Make
sure the primary controller is in the add mode. And then power on
the device through micro USB. The device will auto start the NWI
(Network Wide Inclusion). Red LED will flash every second and
continue 30 seconds. And it should be included in 5 seconds. Red
LED will light ON one second. Rotating to area A(shown in Fig. 1)
and touch 3 times can abort NWI mode.
There is a touch button on the front side. The button carries out
manual inclusion, exclusion and reset to default.
1. Include: Pointing the arrowhead to area A first (shown in Fig.
1). Pressing the button three times within 1.5 seconds. The red
LED will light up for 1 second if succeed.
2. Exclude: Pointing the arrowhead to area A first. Pressing the
button three times within 1.5 seconds.
3. Reset to default: Pointing the arrowhead to area A first.
Pressing button four times within 2 seconds and hold at fourth.
The red LED will light for 3 seconds, release the button within
2 seconds while the LED goes out. The LED will flash for 1
second if reset succeed, or LED will flash once
.
Notice
: Including a node ID allocated by Z-Wave
TM
Controller
means “
Add
” or “
Inclusion
”. Excluding a node ID allocated by
Z-Wave
TM
Controller means “
Remove
” or “
Exclusion
”.
Function
This device can control dimmers in group 2 using three ways:
Dimmer, Timer, and Binary Switch. Point the arrowhead to area
A(shown in Fig. 1 and Fig. 2) then hold the button, release after
the red LED go out. One beep means entering Timer mode or two
beeps means entering Dimmer mode. The device can switch to
Binary Switch mode automatically when fitting horizontal.
1
