＊
PIR Warm Up
When the device power on, the PIR need to warm up before the
operation. The warm up time about 1 minute, the LED will flash in
every 2 seconds. After finish the procedure the LED will light ON three
times.
＊
Wake
When the device power on, the device will wake about 20 seconds. In
this duration, the controller can communicate with the device. Normally
the device is always sleeping to save the battery energy.
Over The Air (OTA) Firmware Update
The device support the Z-Wave firmware update via OTA.
Let the controller into the firmware update mode, and then press the
tamper key once to start the update.
After finish the firmware download,
please don't remove the
battery
, otherwise it will cause the firmware broken, and the device
will no function.
After the LED stop flash, it is recommended that the user power up the
device.
Caution
: After remove the battery, please wait about 30
seconds, and then re-install the battery.
Battery Installation
User need change the battery while the device is showing battery low
message. Please make sure to replace the battery with a 1-minute
interval. Normally the device would flash the light right after replacing
it with a new battery.
The battery type is CR123A, 3.0V.
Open the front cover and do following steps:
1. Use a screwdriver to loosen the screw on bottom side. (step 1)
2. Slide up the front cover. (Step 2)
Change the battery
3. Slide down the front cover. (Step 3)
4. Lock the screw on bottom side. (Step 4)
5
