Association
1.
The PAU05 is an always listening
Z-Wave device, so associations may
be added or removed by a controller
at any time. Or If your controller re-
quires to have the PAU05 send a
'node information frame' or NIF for
associations, then pressing the
On/Off button three times within 2
seconds will cause the PAU05 to
send its NIF.
Note: The device support 1 groups.
The group 1 is for receiving the re-
port message etc. A group one sup-
port 5 nodes maximum.
※
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node
ID allocated by Z-Wave Controller means exclusion.
※
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
LED Indication
To distinguish what mode the switch is in, view from the blue LED for identification.
State Type
LED Indication
Normal
When the power is turned on, its LED is always on. (Blue LED)
No node ID
Under normal operation, when the Switch has not been allocated a node ID,
the blue LED flashes on and off alternately at 2-second intervals. By pressing
On/Off button, it will stop flashing temporarily.
Learning
When PAU05 is in learning mode, blue LED flashes on and off alternately and
repeatedly at 2 second intervals.
Programming
1.Network health
Press the button once to enter the network health test. According to the test results,
the LED light will flash three times. LED color meaning is as follows:
LED color
Description
Green
Network health is good.
Yellow
Network health is acceptable but latency can be observed occasionally.
Red
Network health is insufficient because frames are dropped.
2. Z-Wave’s Configuration
Configuration
Parameter
Function
Size
(Byte)
Value
Unit
Default
Description
1
LED mode
(Blue LED)
1
0-1
0
0: LED on
1: LED off
2 LED mode (Blue LED):
Whenever the AC power return from lost, PAU05 will restore the LED mode which
could be LED off
、
LED on. The default setting is LED on.
3. Firmware update over the air (OTA)
PAU05 is based on 500 series SoC and supports Firmware Update Command
Class, it can receives the updated firmware image sent by controller via the Z-
wave RF media. It is a helpful and convenient way to improve some function if
needed.
Command Classes
The Repeater supports Command Classes including…
Command Class
Version
Required Security Class
Z-Wave Plus Info
2
None
Version
3
Highest granted Security Class
Manufacturer Specific
2
Highest granted Security Class
Security 2
1
None
Device Reset Locally
1
Highest granted Security Class
Association
2
Highest granted Security Class
Association Group Information
1
Highest granted Security Class
Powerlevel
1
Highest granted Security Class
Configuration
1
Highest granted Security Class
2
