PAU05
Z-Wave Range Extender Repeater
Introduction
The Range Extender Repeater is a Z-Wave™ enabled device (interoperable, two-
way RF mesh networking technology) and is fully compatible with any Z-Wave™
enabled network. Every main powered Z-Wave enabled device acts as a signal
repeater and multiple devices result in more possible transmission routes which
helps eliminate “RF dead-sports” Z-Wave™ enabled devices displaying the Z-
Wave™ logo can also be used with it regardless of the manufacturer, and ours can
also be used in other manufacturer’s Z-Wave™ enabled networks.
The product supports Over The Air(OTA) feature for the products firmware upgrade.
Adding to Z-Wave
TM
Network
This product can be operated in any Z-Wave network with other Z-Wave certified de-
vices from other manufacturers. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the network.
The table below lists an operation summary of basic Z-Wave functions. Please refer
to the instructions for your Z-Wave
TM
Certificated Primary Controller to access the
Setup function, and to Add/Remove/associate devices
Function
Description
Annotation
No node ID
The Z-Wave Controller does not allocate
a node ID to the Switch.
LED 2-second on, 2-second off
(Blue LED)
Add (Inclusion)
1.
Put your Z-Wave controller into
inclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing Include button of PAU05
three times within 2 seconds will
enter inclusion mode.
Remove
(Exclusion)
1.
Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
2.
Pressing Include button of PAU05
three times within 2 seconds will
enter exclusion mode.
3. Node ID has been excluded.
LED 2-second on, 2-second off
(Blue LED)
Reset
1.
Pressing Include button of PAU05
three times within 2 seconds will
enter inclusion mode.
Use this procedure only in
the event that the primary
controller is lost or
otherwise inoperable.
2.
Within 1 second, press Include
button of PAU05 again for 5
seconds.
3.
IDs are excluded.
SmartStart
1.Product has a DSK string, you can key
in first five digit to increment smart
start process, or you can scan QR
code.
2.
SmartStart enabled products can be
added into a Z-Wave network by
scanning the Z-Wave QR Code
present on the product with a
controller providing SmartStart
inclusion. No further action is
required and the SmartStart product
will be added automatically within 10
minutes of being switched on in the
network vicinity.
*notice1:The QR code can be found
on the device PAU05 or in the box.
1
