RF Power (peak)
+5dBm (peak), -10dBm (Average)
FCC ID
RHHPAT12
Specifications are subject to change and improvement without notice.
Troubleshooting
Symptom
Cause of Failure
Recommendation
The device can not
join to Z-Wave™
network
The device may in a Z-
Wave™ network.
Exclude the device
then include again.
For Instruction to http:// www.philio-tech.com
Overview
Adding to Z-Wave
TM
Network
This product can be operated in any Z-Wave network with other Z-Wave certified de-
vices from other manufacturers. All non-battery operated nodes within the network will
act as repeaters regardless of vendor to increase reliability of the network.
The table below lists an operation summary of basic Z-Wave functions. Please refer
to the instructions for your Z-Wave
TM
Certificated Primary Controller to access the
Setup function, and to Add/Remove/associate devices
Function
Description
Annotation
No node ID
The Z-Wave Controller does not allocate a
node ID to the Switch.
LED light will flash for 30
seconds.
Add
(Inclusion)
1.
Set your Z-Wave controller into
inclusion mode by following the
instructions provided by the controller
manufacturer.
LED light will flash slowly.
2
Summary of Contents for PAT12-A
Page 1: ......
