Philco PW6608, User Manual

Page: 9 / 24

9
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine These
filters prever the foreign substances and dirt in
the water to enter into the machine. Filters
should be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
Child Lock
Use child lock function to prevent children from
tampering with the machine. Thus you can avoid
any changes in a running programme.
When the Child Lock is active and the
machine is running, you can switch the
machine to Pausemode without deactivating
the Child Lock by turningthe Programme
Selection knob to On/Off position.When you
turn the Programme Selection knob
afterwards,the programme will resume.
To activate the Child Lock:
Press and hold 1st and 2nd Auxiliary Function
buttons for 3 seconds. The lights on the 1st and
2nd Auxiliary Function buttons will flash while you
keep the buttons pressed for 3 seconds.
To deactivate the Child Lock:
Press and hold 1st and 2nd auxiliary function
buttons for 3 seconds while any programme is
running. The lights on the 1st and 2nd Auxiliary
Function buttons will flash while you keep the
buttons pressed for 3 seconds.
Changing the speed and temperature
settings for auxiliary functions
Depending on the step the programme has
reached,you may cancel or activate the auxiliary
functions; see, "Auxiliary function selection".You
may also change the speed and temperature
settings;see, "Spin speed selection" and
"Temperature selection.”
If no change is allowed, the relevant light
will flash for 3 times.
Canceling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be canceled.
End / Cancel light will flash continuously to notify
that the programme has been canceled.Your
machine will end the programme when you turn
the Programme Selection knob; however, it does
not drain the water inside. When you select and
start a new programme, the newly selected
programme will start depending on the step the
previous programme was canceled in. For
example, it may take in additional water or
continue to wash with the water inside.
Depending on the step where the
programme was canceled in, you may have
to put detergent and softener again for the
programme you have selected anew.
Standby mode
When the machine does not make any washing
for approximately 4 minutes, it switches to
Standby mode to save energy. Unnecessary
indicator lights andindicators will turn off in this
mode.Thus, maximum energy saving is ensured.
To exit the Standby mode,turn the Programme
Selection knob or just press any button.