Philco PLD 14840, User Manual

Page: 20 / 32

1
2
9. Clean the filter under the water tap and
put it back in the pump into the special
guides.
10.
Make sure that you tighten correctly
the filter to prevent leakages.
11. Put the flap back and close the drain
pump door.
The inlet hose filter and the
valve filter
It could be necessary to clean the filters
when:
• The appliance does not fill with water.
• The appliance fills with the water for a
long time.
• The indicator of button
4
flashes and
the display shows the related alarm. Re-
fer to 'Troubleshooting'.
Warning! Disconnect the mains plug
from the mains socket.
To clean the water inlet filters:
1. Close the water tap.
2. Remove the water inlet hose from the
water tap.
3. Clean the filter in the inlet hose with a
stiff brush.
4. Remove the inlet hose behind the ap-
pliance.
5. Clean the filter in the valve with a stiff
brush or a towel.
45°
20°
6. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
7. Open the water tap.
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (6) of 'To
clean the drain pump'.
If necessary, clean the pump.
20