Philco PLD 14840, User Manual

Page: 12 / 32

Set this programme to have a good washing results and decrease the energy consumption. The time of the
washing programme is extended.
The washing temperature of the washing phase may differ from the temperature declared for the selected pro-
gramme.
CONSUMPTION VALUES
At programme start the display shows the duration programme for the maximum
load capacity.
During the washing phase the programme duration is automatically calculated and
can greatly be reduced if the laundry load is lower than the maximum load capacity
(e.g. Cotton 60°C, maximum load capacity 8 kg, the programme duration exceeds 2
hours; real load 1 kg, the programme duration don’t reach 1 hour).
When the appliance is calculating the real programme duration a dot blinks in the
display.
The data of this table are approximate. Different causes can change the data: the
quantity and type of laundry, the water and ambient temperature.
Programmes Load
(Kg)
Energy con-
sumption
(kWh)
Water con-
sumption (li-
tre)
Approximate
programme
duration (mi-
nutes)
Remaining
moisture
(%)
1)
Cottons 60 °C 8 1.60 72 168 52
Cottons 40 °C 8 1.00 72 164 52
Synthetics 40 °C 4 0.60 50 110 35
Delicates 40 °C 4 0.70 60 91 35
Wool 30 °C 2 0.35 57 58 30
Standard cotton programmes
Standard 60 °C
cotton
8 1.04 46 208 52
Standard 60 °C
cotton
4 0.65 45 156 52
Standard 40 °C
cotton
4 0.49 44 156 52
Off Mode (W) Left On Mode (W)
0.05 0.05
The information given in the chart above are in compliance with the EU Commission regulation
1015/2010 implementing directive 2009/125/EC.
1) At the end of spin phase.
BEFORE FIRST USE
1. To activate the drain system, put 2 litre
of water in the main wash compartment
of the detergent dispenser.
2. Put a small quantity of detergent in the
main wash compartment of the deter-
gent dispenser. Set and start a pro-
gramme for cotton at the highest tem-
perature without laundry. This removes
all possible dirt from the drum and the
tub.
12