Philco PHEM 1050, User Manual

Page: 29 / 168

27 Revision 10/2017 Copyright © 2017, Fast ČR, a. s.
EN
PART 9: FAILURES HANDLING
• This chapter will instruct you some errors that may
encounter and the solutions.
• If there are some failures cannot be resolved by the following
methods, please contact with the customer sevice center.
Problem Cause Solutions
The coffee temperature is too
low.
The coffee cup was not pre-heated. Wash the coffee cup with hot water
before making coffee.
Several minutes have passed since
the last time of coffee making, so
the brewing unit and the internal
pipes are already cold. Make some more cups of coffee.
Coffee only comes out from
the coffee spout drop by drop.
Over fi ne coffee powder or coffee
bean has been grounded too fi ne. Adjust the grinding wheel to a rough
state or use the suitable coffee
powder.
Brewing unit fi lter was blocked. Run the brewing unit washing
program.
Insuffi cient coffee oil. Picked the wrong coffee bean type. Use the suitable coffee beans.
The grinder arising noises.
There are foreign objects in the
grinder. Make coffee again, if it still failures,
please contact with the customer
sevice center.
Screen always indicates
“EMPTY TRAY”. The sheetmetals at the end of the
drip tray are dirty or wet. Wipe the sheetmetals to dry
(refer to P24)
Screen always indicates
“INSTALL TRAY”. Coffee grounds in the bottom of the
machine are not cleaned. Clean the coffee grounds in the
bottom.
Screen always indicates “FILL
WATER TANK”, but the water
tank is full. The water tank inductor is trapped. Clean the water tank
(refer to P25).
Screen always indicates
“FILL BEANS”, but the bean
container is full.
The bean container is too oily and
sticky for coffee beans. 1. Stir coffee beans in bean
container.
2. Observe if the coffee beans are
over roasted or charcoal roasted.
3. Clean the beans container
(refer to P25).
“Errors”is displayed.
The coffee machine failures, cannot
continue to be used. Switch off the main power, and
contact with the customer sevice
center.