EN - 5
08/2016
Copyright © 2016, Fast ČR, a. s.
Never install your refrigerator-freezer near heat source and direct sun shins
The dimensions of refrigerator are shown in the fi gure below.
Electrical requirement
WARNING:
DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fi re or electrical shock.
Before you move your refrigerator-freezer into its fi nal location, it is important to make sure you have the
proper electrical connection.
Recommended earthing method
A 220~240 Volt /50 Hz AC only 10 ampere fused and properly earthed electrical supply is required. It is
recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do not use an extension cord.
NOTE:
Before performing any type of installation, disconnect the refrigerator-freezer from the electrical source.
When you are fi nished, connect the refrigerator-freezer to the electrical source and reset the control to
the desired setting.
Leveling
If the refrigerator-freezer is not leveled during installation. The doors may not close or seal properly, causing
cooling, frost, or moisture problems. It is very important of the refrigerator-freezer to be level in order to
function properly.
To level your refrigerator-freezer you may either turn the level leg clockwise to raise that side to the refrigerator-
freezer or turn counter – clockwise to lower that side.
NOTE:
Having someone push against the top of the refrigerator-freezer take some weight off the leveling leg.
This makes it easier to adjust the leveling leg.
