Phil & Teds Inline Dash, Survival Manual

Page: 9 / 13

inline
TM
buggy
depress nib springs and insert hinge
ends into pull bar holes.
note hinges are marked with L and R
denoting left and right when viewed from
behind buggy.
r feed retaining strap beneath rear of sunhood,
loop it around handle and connect clip.
warning never use baby & toddler buggy
without using retaining strap.
note do not lift buggy using double kit.
damage to double kit hinges may occur.
s double kit has a recline feature.
to activate: undo both zips that run around
rear of seat.
double buggy
t to attach double kit to rear of buggy
(2 toddlers position): start with buggy
seat in upright position. remove hinges
from double kit. align double kit tubes
with supports on back of buggy frame.
depress nib springs on supports and slide
double kit on, ensuring nib springs pop
through holes on double kit frame. load
heavier toddler in front seat first, then
place lighter toddler in double kit at rear.
always unload rear toddler first.
warning: never use double kit without
toddler in front seat.
folding
remove double kit if attached in rear position.
u depress and hold in red safety button on
inside left of handle, whilst pulling up frame
release triggers on both sides, as shown.
allow seat back to fall backwards.
v lift cross bar allowing front wheel to
fold under frame. press frame flat until fold
lock clicks into place.
add ` adapt
other products available for dash:
buggy covers
• single and double stormy weather covers
• single and double sunuy days covers
buggy beds and liners
• cocoon • lamb skin liner
• race seat liner • sponge ted liner
• buggy bunny liner
• snuggle & snooze sleeping bag
buggy storage
• blazing saddles pannier bags
• up & away buggy travel bag
• hang bag & belt
• shop & drop
4