PHI VILLA E02GF-039-BU, Use And Care Manual

Page: 29 / 32

OPERATION INSTRUCTIONS
gas valve / regulator hose connection (Figure 15) inlet tube / bellows connection (Figure 16)
cylinder / regulator connection (Figure 13) gas valve / bellows connection (Figure 14)
Leak test
1. Always perform the leak test as described below before lighting this appliance or each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak, disconnect the propane supply
and call a gas appliance service shop or your local propane gas supplier.
To prevent fire or explosion hazard when testing for a leak:
1. Make 2~3 oz. of leak solution by mixing one part liquid dishwasher detergent and three parts water. Noted: make sure control
knob is “OFF”.
2. Apply several drops of solution where the cylinder attaches to regulator, (see Figure 13), inspect the solution at the connection
looking for bubbles. If NO bubbles appear, the connection is secure. If bubbles appear, the connection has the leak, disconnect the
regulator, reconnect, perform another leak check. If you continue to see bubbles after several attempts, cylinder valve is defective
and should be returned to cylinder’s supplier.
3. Apply several drops of solution where gas valve attaches to bellows, (see Figure 14), where gas valve attaches to regulator hose,
(see Figure 15), and where inlet tube attaches to bellows, (see Figure 16). If NO bubbles appear, the connections are secure. If
bubbles appear, the connection has the leak, disconnect, reconnect, perform another leak check. If you continue to see bubbles
after several attempts, both parts are defective and should replace with the new ones.
To perform a leak test:
10
LIFE GETS BETTER WITH PHI VILLA