Installation:
WARNING:
Make sure the fireplace INSERT controls are in the OFF position and the
INSERT is NOT plugged in.
CAUTION:
Place a piece of cardboard or protective sheet on the floor in order to
avoid scratching the decorative surface of your mantle during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
Step 1:
Attach all PLASTIC CONNECTOR [X] to the PANELS [H, K, F, E, G, J and C]
as shown in Fig.A (2 screws for each PLASTIC CONNECTOR). Attach the LEFT
UPPER SIDE PANEL [H] to the LEFT LOWER SIDE PANEL [K] using 1
CONNECTOR [S] and 4 Large KD SCREWS [P]. Attach the RIGHT UPPER SIDE
PANEL [G] to the RIGHT LOWER SIDE PANEL [J] using 1 CONNECTOR [S] and 4
Large KD SCREWS [P].
NOTE: If the KD SCREW(S) do not fit during assembly, loosen the 2 screws to adjust
the PLASTIC CONNECTOR until the PANELS/KD SCREWS can be installed.
Fig. A
