Phoenix Audio Technologies, 16 Goodyear Suite 120, Irvine, CA 92618; Tel (818) 937-4774
Fax (818) 859-1054
www.phnxaudio.com
Controllable input level and phantom power
supply via free downloadable utility
Phoenix’s
proprietary
echo
canceling,
beamforming, noise canceling, and AGC
algorithms with no gating, to prevent the loss of
critical information
Specifications
16KHz
sampling
frequency;
100Hz-8KHz
bandwidth
Two levels of Echo Canceling aggressiveness and
three levels of Echo Canceling speed.
Controllable tail length – up to 200 ms.
Residual noise suppressed to the environment
noise level to prevent pumping noise
Eight preset color filters for both the output and
the speaker signal
Low delay (10msec)
Microphone inputs connected to the tip and
ring of IN1 and IN2. *Units are preset to Mic
level with 6dB boost and Phantom On. The
following microphone settings are available
using the setup software:
o
Mic level (140mV peak-to-peak)
o
Line level (2V peak-to-peak)
o
add 6dB boost (In1&2 Only)
o
Optional 2.8V power supply (phantom)
*Units are preset to Mic level with 6dB boost and
Phantom On
Note: User should use the provided dual split
microphones connected to the tip & ring of both IN1
& IN2. (Identical single microphones could be used
in place of the dual split microphones. Option to use
only one Input is viable)
The far end input is via USB connection only.
Notes:
1)
Far-End Input will be received through the
USB channel
Audio Input (mic jack) of system is connected to
the tip of OUT1.
The following output settings are available using
the setup software:
o
Line level: 2V peak-to-peak
o
Mic level: 200mV peak-to-peak
*Units are preset to Line level
Note: Output will be transmitted through the
USB channel if it’s active
Speaker connected to the tip and ring of OUT2.
The output setting is :
o
Line level only: 2V peak-to-peak
How To Connect:
IN1 - Microphone Input: connect your microphone
input into this jack
IN2 – Microphone Input: connect your microphone
input into this jack
OUT1–Audio Out: Connect OUT1 to your system’s
audio
input.
NOT
REQUIRED
FOR
USB
COMMUNICATION
OUT2 – Speaker: Connect OUT2 to your loudspeaker
amplifier.
Dimensions
Not Required
Connect to
Speaker/Amplifier
