Receiver Menu
Setup
"SQL--1": Squelch level function. Adjust the squelch level according to local
environment to decrease white noises.
Press up or down button to enable the receiver search for the least interference
frequency available in the local area.
"LOC": Lock Function. Press up or down button to lock or unlock the receiver
channel.
1-
2-
3-
Install fresh batteries in the transmitters.
Connect the AC power adapter to a wall outlet and to the back of the receiver.
Screw antenna A, B in, and position them 60 degrees apart from each other.
Connect one of the two outputs available at the back panel to the next stage in
your system. Typically, use the 1/4" output to connect to unbalanced equipment
such as consumer-level receivers, amplifiers, and mixers. Connect to professional
equipment using the XLR output (cable not included).
Make sure the volume of your speaker is off, turn on the receiver and the transmit-
ters. Short press the SET button for menu selection. For auto scan feature, short
press SET button until "AUT-CH" is shown on the LCD screen, then press UP
button to confirm the setting. The system will automatically select the least-interfer-
ence best signal channel.
Press SET again after frequency selection, or press UP button after auto scan
function shows up, and you will see LCD screen shows "IR---" status. Aim the
transmitter's IR window at the receiver's IR window to begin pairing. When the
pairing process is completed, the receiver’s screen will show RF signal bars on
the left side and the antenna icon above the frequency will show which antenna is
receiving signals.
1-
2-
3-
4-
5-
6-
A.Set up the system
Operating Instructions
