23
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
HDMI OUT
HDMI IN
LAN
RS232 IN
HDMI to CAT5e/6 with LAN/IR/RS232
Transmitter
1
2
3
4
1
HDMI OUT:
Connect to HDMI display for instant image display or
cascade with another family type Transmitter. The unit will detect
CAT5e/6/7 output's EDID when it obtain a 4Kx2K EDID and send out
the signal accordingly to other output ports. If CAT5e/6/7 output
is without a 4Kx2K's EDID the unit will detect all output's EDID and
send out the signal that all outputs can accept.
This device obtain the last memory function therefore, the device
will use the last CAT5e/6/7 output port's EDID when CAT5e/6/7
output port is not connected after power cycling.
2
HDMI IN:
Connect with source equipment such as DVD/Blu-ray or
PS3 player.
3
LAN:
Connect to intranet or internet service system for a total
sharing rate of 100Mbps within the link of Transmitter.
Warning: DO NOT connect this slot with any of the CAT5e/6/7 port,
doing so may trigger a power shot down and ruin the device.
4
RS-232 IN:
Connect to a PC/Laptop or RS-232 enabled device (with
supplied 3.5mm Phone Jack to D-Sub 9-Pin female adaptor) to
transmit of RS-232 commands.
4
6.2 Rear Panel
POWER
DC 24V
CAT5e/6 OUT
IR 1
BLASTER
USB
LINK
IR 2
EXTENDER
1
2
3
4
5
6
7
1
POWER LED:
Once the power supply is connected the LED will
illuminate.
2
DC 24V:
Plug the 24V DC power supply into the unit and connect
the adaptor to an AC outlet.
3
IR 1 BLASTER:
Connect with the supplied IR Blaster to blast out the IR
signal received from the Receiver side. Place the IR Blaster in direct
line-of-sight of the equipment to be controlled.
4
IR 2 EXTENDER:
Connect with the supplied IR Extender to receive IR
signal from Transmitter side and blast out at Receiver side. Ensure
that remote controller being used is within the direct line-of-sight of
the IR Extender.
5
USB:
This slot is reserved for fi rmware update only.
6
LINK LED:
This LED will illuminate when both the input source and
output display signals are connected through CAT cable. When
it blinks regularly it states the display is NOT sending signals to
Receiver but the Transmitter and Receiver are linked and if it blink
irregularly it states an error has occurred.
7
CAT5e/6/7 OUT:
Connect this port to CAT5e/6/7 to HDMI Receiver
with CAT5e/6/7 cable to extend the signal up to 100m.
