7
INITIAL SETUP
1
CONNECT SOURCE DEVICES
Connect your source devices into the input ports using a High Speed HDMI cable or better (not supplied). It is
recommended to connect devices from Input 1 to Input 8, although you can connect them in any order you wish.
2
CONNECT SINKS
Sink devices are connected to ports 1-8 via category cable (see cabling advice at the start of this guide) from the
Output port to the supplied receivers. Complete the connection from the receiver to the Sink device (i.e. your TV)
via a HDMI cable.
For Output ports 9 and 10, connect sink devices directly via high speed HDMI cables. Once all connections have
been made, turn the matrix on by connecting the power supply to the mains.
3
CONNECT INFRARED
Using the supplied IR pairs, insert the IR Emitter (matte) into the relevant Infrared Out port (for example Out 1 for
Input 1) and attach the bud to the front of the source device, over the IR window. On the sink device (i.e TV) place
the IR Receiver (shiny) in a visable location and plug the end into the RX port on the receiver. Each IR port has an
LED which flashes Red when IR is transmitting and flashes green when IR is being received
4
CONNECT RACK EARS
You can mount the system either at the front or back with the supplied rack ears. Simply screw in the supplied M4
screws to connect the rack ears to the matrix.
5
NETWORK CONNECTION
The matrix is designed to be on and connected to an active internet connection at all times. It will operate correctly
when not connected to a network (or the internet) but certain functions will not be available. Connect a standard
Ethernet cable between the ethernet port and your router/network switch, cross over cables are not supported.
