9
REFRIGERATOR COMPONENTS
1. Door switch
2.
LED light:
White LED light.
3. Air intake vent:
Be careful not to block off. If air intake vent is blocked, the chamber temperature
becomes unstable. Also be careful not to insert the finger or enter the foreign materials.
4. Air circulating fan:
Circulate the cooled air in the chamber.
5. Air exhaust vent:
Be careful not to block off.
6.
Access port:
This port allows cables to be passed into the chamber.
Note:
If an instrument requiring a power source is placed inside the chamber, the cable can be led
through the access port. After installation, a rubber cap should be used to seal the access port. Failure
to do this can affect the temperature uniformity inside the chamber and lead to condensation on the
outside of the access port.
7. Caster:
Mounted on the back side. When moving the unit, tilt the unit backward a little for easy
carrying.
8. Leveling foot:
Adjust the height by screw bolt to install the unit in level.
9. Space for a temperature recorder:
Location for an optional temperature recorder. (page 30)
10. Key lock:
Insert the key and turn to the clockwise 180
o
with pressing into the head of lock when lock
the doors.
11. Shelf
12. Door:
Consists of double pair glass with heat ray reflection film. Be careful not to break the glass.
13. Control panel:
Displays operating condition of the unit and used to set chamber temperature etc.
(page 10)
14. Evaporating tray:
Places in rear bottom of the frame. Pull out forward for removing. (page 24)
15. Power switch (MPR-S163-PE and MPR-S313-PE only):
This is for turning ON/OFF the power to the
unit. (ON-“l”, OFF-“
○
”)
16. Exhaust vent cover (MPR-S313 only):
Always install the exhaust vent cover on the back of the shelf
when the shelf is located at the front of the air exhaust vent.
17. Space for battery mounting box:
A battery mounting box can be attached here. Switch on the
battery switch of the battery mounting box. (page 21)
18. Drain board:
The samples can be placed on a drain board.
19. Drain cap:
Remove the cap when the water resulting from defrosting is drained. The drained water is
evaporated in the evaporating tray under the unit.
Attach the cap after drainage.
Summary of Contents for MPR-S163 Series
Page 2: ......
