8
(7) MM INPUT 1, 2, 3 (RCA) Terminal
Input terminal (RCA) for EA-2000T (MC step-up transformer) and MM cartridge.
(9) OUTPUT (RCA) Terminal
This is an unbalanced equalizer output (RCA) terminal. It connects to the RCA input
terminal of the line level (150
-
250m
Ｖ
) such as AUX terminals of a preamplifier.
(10) OUTPUT (XLR) Terminal
This is a balanced equalizer output (XLR) terminal. It connects to the XLR input
terminal of the line level (150-250m
Ｖ
) such as AUX terminals of a preamplifier.
Rear Panel
（
Left
）
Rear Panel
（
Right
）
Do not connect to a phono input terminal of a preamplifier that has a phono
amplifier inside. It may go to maximum input and distort the sounds.
Caution
(8) GND Terminal
Follow the connections diagram for wiring the attached GND cable.
An XLR connector is adopted on the OUTPUT for this unit (balanced connection)
The pins are set as shown in the diagram pin = GND pin = HOT pin = COLD.
Some pre-amplifiers are set as pin = GND pin = COLD pin = HOT
and in this case the input signal and output signal are played as an anti-phase.
In order to correct the phase, change the connection so that the wiring of the
XLR connector pin and pin at one side of the balanced cable are inverted.
Notice
GND
HOT
COLD
DC IN
MODEL EA-2000EQ
GND
GND
GND
1
2
3
OUTPUT
INPUT
L
MODEL EA-2000EQ
DC IN
GND
GND
GND
1
2
3
OUTPUT
INPUT
R
(11) DC IN Connector
The DC power relay cable (from accessories) connects to the power supply.
(11)
(11)
(10)
(10)
(9)
(9)
(8)
(7)
(8)
(7)
