3
period, the light turns on continuously. After one
minute is expired, the light will turn off.
Walk through the detection area, the light will turn
on continuously. If and when movement is
ceased, the light will be on for one second before
turning off.
(1) TIME ADJUSTMENT
The TIME adjustment controls how long the light will
stay on after the last motion has been detected. Time
setting is adjustable from 5 seconds to 12 minutes.
(FIGURE 8)
ABOUT 5 SECONDS
ABOUT 12 MINUTES
FIGURE 8
Note:
T serves as a short-time impulse, which allows
you to control automatic switching of staircase lighting
or timer.
(2) LUX ADJUSTMENT
The LUX adjustment determines at what light level the
lighting system will start operating when you set the
sensor to automatic operation.
Provisionally turn the LUX control knob clockwise to
the moon (dusk) position (FIGURE 9). Turn the LUX
control knob slowly anti-clockwise until the light comes
on. In this provisional setting mode, the motion
sensor remains inactive during daylight. At dusk
when you find it is the LUX level desired for operation,
simply set the LUX control knob to the position which
becomes active as daylight declines. The light turns
on when you move and turns off when you stop.
Wait for the light to turn off before moving again to test
the sensor.
FIGURE 9
(3) CHANNEL SELECTION
To avoid radio signal interference, and operate
separate banks of detectors on a single remote, you
are able to select different channels through channel
switch. Select channel 1 or 2 on the sensor for
grouping the connected light fixtures in the same or
different zone.
E253R IR Remote Controller
2
3
1
4
FIGURE 10
3-button and channel selection slide switch are shown
on the front cabinet as follows: (FIGURE 10)
AUTO
ON
OFF
CHANNEL SWITCH
LOADING THE BATTERY
(1) Use a flat blade screwdriver to detach the battery
cover from the cabinet. (FIGURE 11)
FIGURE 11
(2) Insert a 12V alkaline battery to the battery
compartment and refit the battery cover. (FIGURE
12)
