12 |
P a g e
OPERATION
Install Tip
Devices must be activated through the online portal before device will
connect. Go to
to activate new devices. The first
connection process should take about 20 minutes but can take longer depending on
cellular reception.
4.1 Initialization
After power and control connections are made, turn power to the device
ON
so device can
begin the connection procedure. While connecting, the display will show “Waiting Conn:”
with a counter showing the number of seconds the device has been trying to connect. The
activation process usually takes 20 minutes but can take longer in areas with poor cellular
service. The
Connection LED
, in the top right corner of the circuit board, will blink when
connected and be always on when unconnected.
4.2 Device Parameters
After device is connected, parameters and their values will scroll across the display. See
, to understand the information being shown. The
IMEI
(International
Mobile Equipment Identity) number is a unique identifier for mobile devices. This can be
used to verify which device you are controlling through the portal.
Figure 13
– Understanding the Display
Table 4
– Scrolling Parameters
Parameter
Description
Iin
4-20 mA Input value
Iout
4-20 mA Output value
T
Temperature in
°
C and
°
F
R1 R2
Status of Relay 1 and Relay 2
X1 X2
Status of Aux 1 and Aux 2
X1 Cycles
Number of times Aux 1 has been cycled
X2 Cycles
Number of times Aux 2 has been cycled
X1 On
Total time Aux 1 has been closed
X2 On
Total time Aux 2 has been closed
Next Msg
Countdown until next update is sent to portal
Signal
Strength
Local
Time
IMEI
Number
Scrolling
Parameters
