Solaris Series | MusicGarden
MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]
Subwoofer Speaker Installation
• It is recommended to add a 4” to 6“ layer of crushed rock or gravel
underneath the subwoofer. This will help protect the speaker from the
ground water and minimize frost heaving.
• All subwoofers should be mounted such that the bottom edge of the
vent tube cover is 3” to 5” above the final landscaping.
• Be sure to completely wire your system and fully test it before
back-filling the subwoofer hole.
4. Connect the left input channel to the
Blue (+) wire and the Black (-) wire from
the subwoofer.
Connect the right input channel to the
Brown (+) wire and the Yellow (-) wire
from the subwoofer.
3. Dig a hole sufficient to bury the
speaker to the correct depth (noted
above) and to also accommodate 4-6” of
gravel or crushed rock under the
subwoofer housing.
2. Install the cap by threading it onto the
end of the port tube clockwise.
1. Remove speaker from the box.
6. Fully wire the rest of your system and
test to make sure the system is
performing correctly.
9. Back fill the subwoofer hole.
3” to 5”
5. If daisy-chaining, be sure to also
connect the wires going to the next
speaker in the chain. Be sure to follow
standard protocol for polarity and make
sure the subwoofer is wired with the
same polarity as the MG4 units.
Daisy Chaining Wiring
Wire Nuts
Speaker or
Subwoofer
Daisy-Chained
Speaker or
Subwoofer
Signal Wire
Blue +
Black -
+
__
-
-
1.
2.
+
