Solaris Series | MusicGarden
MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]
2. For in-ground installation, dig a hole 6
- 8" in diameter and 8" deep in the
precise location where the speaker will
be placed.
1. Remove speaker from the box.
3. Strip and prepare wire ends for your
desired speaker configuration.
4. Pass the wire from the amplifier
through the side hole in the mounting
spike and out the top end. If
daisy-chaining, pass the wire for the next
speaker through the hole and out of the
top as well.
DO NOT PASS THE SPEAKER
WIRE(S) OUT OF THE BOTTOM OF THE
MOUNTING SPIKE.
9. Adjust the vertical aiming (tilt aiming) by
loosening the screw in the side of the
mounting bracket assembly. Adjust the
speaker to the desired tilt angle and
re-tighten the screw.
DO NOT ADJUST
THE SPEAKER TO AN ANGLE MORE
THAN 45˚ FROM HORIZONTAL.
7. Position the MG4 speaker in the hole,
ensuring that it is aimed in the intended
direction. The speaker should be deep
enough in the ground that the wire(s)
can be buried at least 1” below the final
landscaping grade. Backfill the hole.
8. Speaker aiming can be fine-tuned
using the included Allen wrench. Loosen
the screw in the bottom of the gooseneck
adapter and gently rotate the speaker into
the desired position. Re-tighten the
screw.
Back
5. Trim the wire from the speaker to the
appropriate length and use the supplied
silicone wire nut to connect the positive
lead from the speaker to the positive
leads on the input wire. If daisy-chaining,
be sure to also connect the positive wire
for the next speaker in the chain. Repeat
this step with the negative leads.
6. Gently place the wire nuts and
speaker cable inside of the mounting
spike and thread the speaker onto the
mounting spike. Be sure to fully tighten
the spike to the speaker mounting
flange. Gently pull on the speaker wires
coming out of the side of the hole to
remove any excess wire inside the
mounting spike.
MG4 Speaker Installation
• PhaseTech recommends using either 14 gauge or 16 gauge
direct-burial rated cable.
• It is best to lay out the direct-burial rated cable to each of the
intended speaker locations before installing the speakers. Once the
speakers are installed and the system has been tested, bury the
speaker cable 3-5” deep in the ground.
Red +
Black -
+
__
-
-
1.
2.
+
