2
ATTENTION:
●
This product left the place of manufacture in perfect condition. In order to
maintain this condition and for safe operation, the user must always follow
the instructions and safety warnings described in this user manual.
●
Avoid shaking or strong impacts to any part of the equipment.
●
Make sure that all parts of the equipment are kept clean and free of dust.
●
Always make sure that the power connections are connected correct and
secure.
●
If there is any malfunction of the equipment, contact your distributor
immediately.
●
When transferring the product, it is advisable to use the original packaging
in which the product left the factory.
●
Shields, lenses or ultraviolet screens shall be changed if they have
become damaged to such an extent that their effectiveness is impaired.
●
The lamp (LED) shall be changed if it has become damaged or thermally
deformed.
PART 2 INSTALLATION
2.1 Mounting:
2.1-1 Hanging
The product can be mounted in a hanging position using the supporting
bracket. The bracket should be secured to the mounting truss or structure
using a standard mounting clamp. Please note that when hanging the unit a
safety cable should also be used
.
2.1-2 Upright
The product can be mounted in an upright or sitting position using the
supporting brackets.
NOTE:
The product can be mounted at any angle and in any position. It is possible to
further adjust the angle of the product using the two adjustment knobs located
on the side of the fixture.
2.2 Special construction for DMX connection.
☆
At last fixture, the DMX cable has to be terminated with a terminator to
reduce signal errors. Solder a 120-ohm 1/4W resistor between pin
2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the
DMX-output of the last fixture.
