SWING M delivery pump / Part 2 Overview, operation and service
Operation
5
4
Figure 46: Cleaning the nozzle
7. Punch the air holes of the nozzle (4) with the pin punch (5) to clear.
6
Figure 47: Cleaning the spray gun
8. Hose down spray gun with water jet.
9. Clean the spray gun with the nozzle brush (6).
10.Switch on the compressor and blow the spray gun dry.
11.Reassemble spray gun.
5.12.6
Cleaning the material hopper
The inside of the material hopper can be cleaned with a
water hose after having been emptied completely.
5.12.7
Drain residual water
1
Figure 48: Opening the cleaning
nozzles
1. Remove the cover from the cleaning nozzle (1) and let the residual
material drain off.
2. Clean the protective grille and material hopper with a water jet.
3. Close the cover (1) again.
4. Fill material hopper with water and switch on the machine so that
the pump is rinsed with water.
5. Remove the cover (1) again and drain the remaining water
completely.
6. Then close the cover (1) again.
NOTE
Never let the pump run dry as this reduces the service life
of the pump.
page 36 / 52