SWING M delivery pump / Part 2 Overview, operation and service
Operation
5.7
Interruption of work
NOTE
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on the
setting time of the material and the length of the interrup-
tion (pay attention to outside temperature).
The guidelines of the material manufacturers have to be
observed regarding breaks.
2
1
Figure 34: Close taps
1. Close the ball valve for mortar (1) on the spray gun.
2. Close the air tap (2) on the spraying gun.
5.7.1
In case of longer interruption of work / break
NOTE
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on the
setting time of the material and the length of the interrup-
tion (pay attention to outside temperature).
The guidelines of the material manufacturers have to be
observed regarding breaks.
2
1
Figure 35: Close taps
1. Close the ball valve for mortar (1) on the spray gun if work is inter-
rupted for a longer period of time.
2. Close the air tap (2) on the spraying gun.
3. Switch off air compressor.
3
Figure 36: Switching off the machine
4. Turn the pump motor selector switch (3) to the "0" position.
page 30 / 52