ENGLISH
ENGLISH
9
1 HOLE INSTALLATION
7
8
10
STOP
Go To Step 10
7 SECURING THREE HOLE FAUCET BODY
From underneath sink, place Washer (
7A
) and Locknut (
7B
) over Pull-Out Hose (
7C
)
and Supply Tubes (
7D
). Thread loosely onto faucet shank (
7E
). Make sure that Handle
(
7F
) is properly aligned to sink. Hand tighten Wing Nuts (
7G
) to Deckplate Shanks
(
7H
). Caution: do not over-tighten wing nuts. Remove any excess putty from around
the outside edge of Putty Plate (
7J
). Tighten faucet firmly to sink and use Flats (
7K
) on
Shank (
7E
) for leverage.
8 ONE HOLE WITH SINGLE POST INSTALLATION
Place Metal Washer (
8A
) and Rubber Washer (
8B
) over center hole of sink and into
the bottom of Mounting Ring (
8C
). Align Mounting Ring (
8C
) to the center of sink hole.
Retract Pullout Hose (
8D
) up through Faucet Body (
8E
), until the pullout hose fitting
is flush with the bottom of Mounting Shank (
8F
). Insert Faucet Supply Tubes (
8G
) and
Mounting Shank (
8F
) through the hole in Mounting Ring (
8C
). Be sure that Protective
Caps
(8J)
are in place.
Note:Tabs (
8K
) on Mounting Shank (
8F
) must be aligned with Grooves (
8H
) inside
Mounting Ring (
8C
).
Note: Do not feed the pullout Hose (
8D
) back down through the spout yet.
9 SECURING SINGLE POST FAUCET BODY
From underneath sink, place Washer (
9A
) and Locknut (
9B
) over Pull-Out Hose (
9C
)
and Supply Tubes (
9D
). Thread loosely onto faucet shank (
9E
). Make sure that Handle
(
9F
) is properly aligned to sink. Tighten faucet firmly to sink and use Flats (
9G
) on
Shank (
9E
) for leverage.
10 QUICK CONNECT & WEIGHT ATTACHMENT
Insert the end of the Pull-Out Hose (
10A
) into the Weight (
10B
). Screw Quick Connector
(
10C
) to the free end of Pull-Out Hose (
10A
).
3
9A
9B
9C
9D
9F
9E
7E
7A
7B
7C
7D
7F
7G
7G
7H
7H
7J
8G
8B
8A
8C
8D
8E
8F
8K
8H
9G
7K
8C
8J
10A
10B
10C
Summary of Contents for Clairmont LF 534 Series
Page 17: ...FRANÇAIS FRANÇAIS 17 ...
