Page
APPENDIX
Checklist
A copy of our Batch Release/Packing List will be attached to the Rota-Loo. Please check that all the
products you ordered have arrived. If any items are missing or any items damaged please contact your
supplier or PFG Group Victoria Pty Ltd.
Kit Parts List
Rota-Loo 950 Chamber
• Incorporating steel reinforced turntable and wheel system as well as the
self-tapped lid with single hole cut out for waste chute.
•
Access Door complete with Diary and direction stickers along with 6
Rubber replaceable latches to ensure unit seals tight to keep heat in and
expedite composting process.
•
6 x Buckets drilled for air and liquid flow and individually numbered 1 to 6
Waste Chute & 2 Side Pods
• 900
mm long waste chute with flange should extra length be required.
Vent Fittings
• Inlet vent complete with screen to keep insects out
•
45 degree 100mm into 300mm pipe for inlet connector
•
45 degree 100mm connectors for outlet piping
•
Wind turbine Sewer Vent and Wind turbine adapter
•
Y-Junction and Water Outlet pipe fittings
•
Fan housing to suit both 12 volt and 240 volt fan
•
12 volt Solar fan or 240 volt fan complete with power lead
Accessories
•
RL650/950 filter pack of 6 filters
•
1 litre bottle of bio-stimulant
•
Any optional items ordered will be shown on the batch release/picking list.
Items and Materials not Supplied
Other items needed not supplied with the Rota-Loo kit:
•
Sand/crushed rock for level base and water proof board or similar to place the Rota-Loo on.
•
PVC piping needed to build the air vent system - 100mm DWV pipe and 45˚ elbows to suit
•
Pipe brackets as required to secure vent piping and PVC Pipe Glue and Priming Fluid
•
Sikaflex 221 for sealing the waste chute (silicone tends to go brittle after a time)
•
Material to attach the waste chute to flooring joists (hoop iron or similar)
• Power source for the fan
If additional screws are required, use Stainless Steel only - (8g x 20 or 8g x 25 SS304 screws)
Optional Materials
•
Insulation for the Rota-Loo and / or vent piping
•
Paint for DWV pipe-work (black to absorb heat or coloured for desired finish
General Tools Guide
•
Phillips Head Screwdrivers or Phillip’s head drill bit
•
Saws to cut the waste chute and PVC piping
•
Drills including a hole saw (111mm ideal) to cut the Vent Pods to fit the Pod Connectors.
•
Measuring Equipment - Level, Plumb bob, Tape measure, ruler, roofing square
• Markers, a white marker is useful when dealing with the waste chute
• Hammer
• Caulking gun
22
