Pfaff coverlock 4852, Owner'S Manual, Page: 15 / 72

13 13
Presserfoot
With standard presser foot 10 use setting
”A” on the spring loaded presser foot latch
for the cover stitch (Prog. 02), the 2 thread
chainstitch (Prog. 01), the 5 thread safety
stitch seam (Prog. 09) and the 4 thread
safety stitch seam (Prog. 08).
Transparent presser foot F from the
accessories can also be used for the cover
stitch (Prog. 02).
For all other programs use standard presser
foot
10 and setting ”B” on the springloaded
presser foot latch.
Changing the presser foot
Switch off the electrical power
To remove: Raise the needle(s) to the
highest position by turning the hand wheel
towards you. Raise the presser foot and
press lever
A at the rear of the presser foot
holder. The presser foot will be released
automatically from the holder. Pivot the
presser foot clockwise until the front half of
presser foot clears holder and remove by
sliding foot away from you towards back of
machine.
To attach: Place the presser foot behind and
perpendicular to the presser foot holder.
Pivot the presser foot counterclockwise
until the pin of the foot is directly under the
presser foot holder clamp. Lower the presser
foot lever and press lever
A , if necessary,
until the foot then clicks into place.
Check: Please lift the presser foot lever to
ensure that the presser foot is properly
locked into place.