pewag servostar, Mounting Instruction, Page: 11 / 36

EN
11
Preparation B:
Wheel bolt adapter
To adjust the adapter, remove the wheel cover and wheel bolt
caps. Remove any dirt, snow or ice.
1a
Move the slide switch of the ratchet to the “open” position.
Please follow the directional arrows in marked order.
1b
Pull out the cable on which the adapter is fixed.
2a Now check whether the pre-assembled adapter fits onto the
wheel bolt.
2b
The clamp must be placed straight and completely on the
hexagon of the wheel bolt for secure attachment.
3a If the adapter is too small and is not fitting on the wheel bolt,
please take the next size of the clamp and the sleeve, mount it
on the adapter and try it again. The offscrewing and screwing
together is happening by hand.
3b
The hexagon of the clamp has to be pushed completely
through the opening of the sleeve. So the clamp can be
fastened correctly to the wheel bolt.
Preparation C:
Wheel-offset adjustment
1
If the adapter touches the rim, the adapter must be extended.
As principle: Screw the adapter as close as possible to the rim
without it touching the rim (as in Fig. 3).
2
There are three different variants to extend the adapter. These
three options are shown in the picture. The offscrewing and
screwing together is happening by hand.
3
When the handle no longer touches the rim, the adaptation is
complete.
Product
description
Arms of
chain
Slide switch
Hand wheel
Ratchet
Chain mesh