pewag servostar, Mounting Instruction, Page: 10 / 36

10
EN
Customer Information
It is absolutely necessary to adjust the chain before first use. As a
result mounting is easier in the course of winter conditions. Smooth
and quick mounting is possible only when chain is optimally
adapted to tyre and rim.
Content for Preparation
1a
+
1b
Adapter for fastening to the wheel bolt
1a
Clamp with wrench width 17, 19 and 21/22 mm
1b
Sleeve for clamp
2a
+
2b
Spacer
3a
Screw long
3b
Screw medium
3c
Screw short
4
+
5
Tools for size adjustment
6
Wrench
Preparation A:
Tire size adjustment
For some tyre sizes an adjustment of the chain dimension is
necessary.
1
Check your tyre dimension
2 Look for it in the dimension setup table (p. 4 & 5)
3
If necessary, remove adjustment elements (marked yellow)
with the enclosed tool as shown in figures 3a-3c.
Explanation table (page 4 & 5)
OK = no adjustment necessary
-1 = remove 1 element
-2 = remove 2 elements
etc.
For removing 2 or 4 elements, always remove the opposite
elements.
Keep the removed parts –this chain can be reused for
other tyre dimension.
Note: These instructions are generally valid and non-binding and
are results of tests and our experience. Therefore, a fitting test
before the first use is urgently recommended.
Check the fit of the chain after approx. 50 m. Readjust if needed
(remove more adjustment elements if the chain does NOT pull
automatically on the tyre).