27
pewag levo hook
EN
buttons (open/close swivel hook, workplace lighting and
status query) will perform the action in question for all the
levo hooks in the network. For the information symbols, the
following applies:
• The battery charge status display shows the charge status of
the weakest battery.
• The status display will light up as soon as at least ONE hook
in the network reports an error.
• The display for contact with a lifting device will light up as
soon as all hooks in the network report the required contact
with the lifting device.
5.6 Disconnecting the pewag levo
hook from the radio control unit
To confirm that the disconnection process has been completed
successfully, the status display on the battery will give two short
flashes.
5.7 Charging station
If only the red LED lights up on the charge status display, the
battery is almost empty and needs to be recharged. Always
use the pewag levo charging station to charge the battery. To
charge the battery, proceed as follows:
1. Release the battery and remove it from the levo hook as
shown in section 5.1 „Removing the battery“.
2. Insert the battery in the pewag levo charging station and lock
it as shown in section 5.1 „Inserting the battery“.
3. Connect the device plug of the pewag levo charging station
to a power source.
The battery will charge automatically and the charging station
does not need to be activated separately.
Among other factors, the charging time will depend on the
surrounding temperature. When all green LEDs light up, the
battery is fully charged. The charging process will terminate
automatically. The battery may then be removed from the
charging station.
Never attempt to charge the battery using a
device other than the original pewag charging
station!
Never attempt to repair the charging station
yourself!
5.8 peTAG
The peTAG is located on the side of the casing, above the
identification plate on the left-hand side. The peTAG is an NFC
chip designed to support you with the regular inspection and
identification of the levo hook. For more detailed information,
please visit petag.pewag.com This link tells you everything you
need to know about the intelligent testing equipment offered by
pewag.
6. Optional equipment and
accessories
In addition to the extensive basic equipment, the following add-
ons are available for the levo hook, which may be integrated
ex works, included in the scope of delivery or purchased
separately at a later point.
These add-ons were designed to make your levo hook even
more powerful.
If you are planning to retrofit modules 6.1, 6.2 and 6.3 of your
levo hook, please note that this must be done by pewag austria
GmbH or an authorised pewag dealer. Please contact your
supplier for more information.
6.1 Magnetic
module with
sensor
The magnetic module
makes it possible to attract
and lift an iron-containing
(ferromagnetic) lifting
devices – such as the
lifting eye of a chain sling
– from a distance. To do
this, open the swivel hook
and lower the levo hook
until the magnet module
has attracted the lifting
device (see fig. 9). As
soon as contact has been
made, the information
symbol „Contact with
lifting device“ will light
up on the radio control
unit once you press the
„Status query“ button on
the remote. Next, lift the
fig. 8: pewag levo battery charging station
fig. 9: Magnetic module with sensor
