Pevino PNG20D-HHB, User Manual

Page: 5 / 44

5
INSTALLATION INSTRUCTIONS FOR WINE COOLER:
1. Please follow the installation diagram when installing the wine cooler. No less than the minimum
installation dimension.
2. The wine cooler draws air from the right side of the ventilation frame and expel through the left side of
the ventilation frame under the front door.
3. The wine cooler has a power switch located on the control panel.
4. The wine cooler requires a standard 240 volt/10 A. power supply. (Or accordingly to different countries
specifications).
5. The power cord is 200 cm. in length and fixed on the right side at the back.
6. As with most appliances of today, the wine cooler has sensitive electronic components which are
susceptible to damage through lightning and electricity supply faults. It is therefore advised to use a power
surge protector to avoid problems of this nature.
In warm climate zones, an air vent or grid, with a minimum ventilation size of 200mm x 50mm MUST be
cut out at the rear top of the back cabinet or at the top of either side of the cabinet, allowing cool fresh air
full access to flow into the 30mm gap located at the rear of the cabinet.
This air vent or grid must not be open towards the same side as other appliances such as ovens. Nor can an
opening be towards an area that is sealed and without access to fresh cool air. Failing to comply with the
above specifications will result in WARRANTY void.
NOTE: The appliance must be positioned so that the outlet and plug is accessible after installation.