Pevino PNG20D-HHB, User Manual

Page: 4 / 44

4
KEEP THESE INSTRUCTIONS FOR ANY FUTURE USE
BEFORE LOADING AND PLUGGING IN THE WINE COOLER
Before using your wine cooler
•
Remove the exterior and interior packaging.
•
Before connecting the wine cooler to power source, let it stand upright for approximately 6 hours.
This will reduce risk of a malfunction in the cooling system from handling during transportation.
•
Clean interior surface with lukewarm water by using a soft cloth.
•
When replacing the illuminating lamp, please select a lamp similar to the original. Shut off the power
supply before replacing the lamp.
Installation of your wine cooler
•
Place your wine cooler on a surface strong enough to support it when fully loaded. Level your wine
cooler by adjusting the levelling legs at the bottom front of the wine cooler.
•
Place the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase energy consumption.
•
Extreme cold ambient temperatures may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the wine cooler into a properly installed wall outlet. Any questions concerning power should be
directed toward a certified electrician or an authorized products service center.
Pay attention to this
•
Store wine in sealed bottles.
•
Do not overload the wine cooler.
•
Do not open door unless needed.
•
Do not cover shelves with aluminium foil or any other material that may prevent air circulation.
•
Should the wine cooler be stored unused for a longer period of time, it is advised, after a good
cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible
formation of condensation, mold or odours.
•
The carbon filter should be cleaned and dried at least once a year.
LEVELLING THE WINE COOLER
ALL wine coolers must be levelled before loading with wine. Your wine cooler is equipped with four
adjustable feet to facilitate easy levelling. It is recommended that you tighten the back feet to the maximum
and adjust the front feet to level the wine cooler.