Pevino PN166D, User Manual

Page: 7 / 64

7
FOR PN7S
The temperature setting can be adjusted from 5
℃
to 18
℃
.
①
” Power”:
control this appliance turn on/off. (Press and hold this button for approximately
②
“UP”: Press once the “UP” button, the temperature will raise 1
℃
.
③
“DOWN”: Press once the “DOWN” button, the temperature will lower 1
℃
.
④
“LIGHT “:
Control the interior light ON/OFF.
In order to reduce energy consumption. This cabinet will automatically switch off the internal
light after 10 minutes. If you want the internal light to remain on continuously. Press and hold
this button for 5 seconds until display show
“LP”. To revert to normal mode. Press and hold
this button for 5 seconds until display show “LF”.
⑤
“DISPLAY”: Display
the set temperature indoor.
⑥
”RUN”:
When
it’s ON, the cooling system runs.
Note: Press "UP" or "DOWN" button for 3 seconds. The actual temperature will be showed on
DISPLAY. It will return to the set temperature by pressing any button.
➢
Setting The Temperature Controls
Press once the button, the temperature will decrease or increase 1
℃
. When exceeding the
minimum value that can be established, it will jump to the highest adjustable temperature
value automatically.
NOTE:
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Cooler will not start.
•
When you use the wine Cooler for the first time or restart the wine Cooler after having been
shut off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the LED readout. This is normal and it is due to the length of
the activation time. Once the wine Cooler is running for a few hours everything will be back to
normal.