4
7
Steering wheel controls
E
R
G
O
N
O
M
IC
S
a
n
d
C
O
M
F
O
R
T
3
Flashing of the speed
The speed flashes:
-
following forcing of the accelerator point
of resistance,
-
when the limiter cannot prevent an
increase in the vehicle speed due to the
profile of the road or on a steep descent,
-
in the event of sharp acceleration.
Exceeding the programmed speed
Pressing the accelerator pedal in order to
exceed the programmed speed will have
no effect unless you press the pedal
firmly
beyond the
point of resistance
.
Good practice
Operating fault
The programmed speed is cleared then
replaced by three dashes.
Contact a PEUGEOT dealer to have the
system checked.
The limiter is deactivated temporarily and
the programmed speed flashes.
To return to the limiter function, reduce your
speed to below the programmed speed.
Switching the function off
-
Place the dial in position
0
or switch off
the ignition to switch the system off.
The last programmed speed remains in the
memory.
In any event, the speed limiter cannot
replace the need to observe speed limits,
nor can it replace the need for vigilance and
responsibility on the part of the driver.
Always pay attention to the profile of the
road and sharp acceleration and stay in
complete control of your vehicle.
To avoid any jamming under the pedals:
-
ensure that the mat and its fixings on the
floor are positioned correctly,
-
never place one mat on top of another.
Summary of Contents for Expert VU 2009
