Version E User Guide 208 Rally 4 - 22/01/2021
P 24
Caution: There is a specific assembly per road surface:
Tarmac assembly specificity: The driveshaft can not be fitted with the locking nut and pin in tarmac
spec; we therefore advise to check the tightening torque of the driveshaft nut after the first run
(400Nm) as well as each service.
Whenever possible, avoid hot-tightening the nut. Clean the thread and replace with new Loctite 648
if the tightening mark has moved more than approximately 1/6 of a turn.
Tarmac Assembly
Gravel Assembly
Spacer 12mm
