EN
FR
ES
DE
NL
IT
petsafe.com
6
B
O
U
N
D
A
R
Y
Z
O
N
E
Transmitter
Pet Area
Note: In many
neighbourhoods,
nearby property lines
may limit how large
the Pet Area can be.
Maximum
32 m range
(53 average steps)
How the System Works
The PetSafe
®
Stay & Play
™
Wireless Fence for Stubborn Dogs has been proven safe, comfortable and effective for pets over 2.3 kg. The system
works by transmitting a radio signal up to 32 m in all directions. You temporarily define the pet area with boundary flags for a visual aid in
training your pet. Your pet wears a receiver collar with contact points that touch his neck, and, once trained, he is allowed to roam freely in the
pet area. When your pet reaches the boundary zone, the receiver collar gives a warning tone before delivering a safe static stimulation through
the contact points to get his attention until he returns to the pet area.
Key definitions
Transmitter:
Transmits the radio signal and is the centre of the pet area.
The transmitter needs to be located indoors.
Pet Area:
Distance from the transmitter where your pet can roam freely.
Boundary Zone:
0.6 m to 1 m wide area outside the pet area where
your pet’s receiver collar will begin to tone and then to deliver static
stimulation. The stimulation will start in the boundary zone and continue
anywhere beyond the pet area.
Note
: The receiver collar is equipped with a safety time-out feature that will
stop correcting after 15 seconds if your pet remains outside the pet area.
Receiver Collar:
Receives the radio signal from the transmitter.
Mode Button:
Turns receiver ON/OFF and adjusts the level of static
stimulation your pet receives outside the pet area.
Receiver Indicator Light:
Indicates the level of stimulation at which the
receiver collar is set. This light also serves as a low-battery indicator.
Receiver Charger:
Charges the batteries inside the receiver collar.
Receiver Charge Jack:
Connection port for charging receiver battery.
Contact Points:
Deliver the safe static stimulation when your pet moves
into the boundary zone.
Power Jack:
Where the power adaptor plugs into the transmitter.
The transmitter is powered by a standard outlet.
Boundary Switch:
Adjust according to the size of the pet area desired.
Note
: Adjusting the switch does not change the level of static stimulation
on the receiver collar.
Power Light:
Indicates when the transmitter is on.
Boundary Control Dial:
Adjusts the distance from the transmitter
to the boundary zone.
Note
: Adjusting the dial does not change the level of static stimulation on
the receiver collar.
Power Loss Alarm:
Sounds an alarm which indicates that the power has been disconnected from the transmitter.
Transmitter
Receiver Collar
Contact
Point
Receiver
Indicator
Light
Mode
Button
Boundary
Control Dial
Power
Jack
On/Off
Switch
I = On
O = Off
Boundary
Switch
+ = High
- = Low
