Petsafe PWW00-14907, Operating Manual

Page: 6 / 16

Customer Care Center 1-800-732-2677 6
OPERATING GUIDE
NOTE: Rinse all fountain parts, including the pump, with warm water
before operating the pet fountain. This will remove any dust or
residue that remain in the system from the manufacturing process.
Refer to the “Pump Maintenance” section of this Operating Guide for
detailed instructions on how to properly clean your pump.
1. As with any electrical appliance, check the electrical power
cord for any tears or damage before use.
2. Remove the lid by placing a finger underneath the tab on the back of
the lid and lift up (
Fig. 1).
3. Rinse the carbon filter thoroughly under cold water before placing
in the fountain. This will remove any loose carbon dust, which is
harmless. A small amount of carbon dust may shed for the life of the
filter. This is normal and not harmful to your pet.
4. Insert the carbon filter. The filter will fit between the two triangular
slots to the right of the pump. Make sure it is pushed all the way
down and that the black side of the carbon filter is facing toward
the pump (
Fig. 2).
5. Place the fountain in a desired location. To protect your floor always
use a protective mat, such as a towel or water resistant placemat.
This will help protect your floor from splashing or spills caused by
your pet.
6. Fill the fountain by pouring water directly into the bowl, this will
prime the pump. Leave at least 1/4 inch of space between the water
level and the rim of the bowl.
7. Attach the lid, press down until you hear it snap in place.
8. Before you plug in the fountain, make sure the electrical power cord,
the adapter and your hands are dry. Connect the in-line plug and
make sure no silver is showing, then plug the adapter into a standard
electrical wall outlet ( Fig. 3).
9. Add water to the bowl as needed. Never let the water level fall below
2 inches from the base of the bowl or you might risk pump failure.
Replacement pumps are sold separately by calling the Customer
Care Center at 1-800-732-2677 or visit www.petsafe.net.
Fountain Disassembly & Cleaning
• Fountain must be cleaned to continue working normally.
• Never wash the filters with soapy water, as the soap residue will seep into
the filters and cannot be removed. Only rinse the filters with water.
• Use only PetSafe® authorized replacement filters.
If unauthorized filters are used it may void the warranty.
• Fountain must be cleaned to continue working normally.
• Never wash the filters with soapy water, as the soap residue will seep into the filters and cannot
be removed. Only rinse the filters with water.
CARBON FILTER: Replace carbon filter every two to four weeks.
• Always rinse the carbon filter prior to use.
• A small amount of carbon dust may be released for the life of the filter,
this is normal and is not harmful to your pet.
• Replace filters more frequently when using the fountain for multiple
pets or pets that produce a lot of saliva.
• Do not use outdoors. Do not run dry. For indoor household use only.
• Do not pull on the electrical power cord to remove the plug from the
electrical outlet.
• To unplug, grasp the plug, not the electrical power cord.
Fig. 3
Fig. 2
Fig. 1