10 1-800-732-2677
Install and Attach Exterior
6A.
You are now ready to work from the outside wall. With B side in
position, mark location of 4 toggle bolt holes. Remove B side of
the pet door.
6B.
Drill marked locations with ½” (13 mm) drill bit.
6C.
Install the toggle bolts and screw caps into the B side. Slide
the B side of the Pet Door into the A side that is already
installed on the inside. The unit will slide together just like it
was in the package.
Fit
Check
Inspect the unit for a snug fit and any gaps that could cause a
draft or water penetration. Either tighten the fit or use closed cell foam and/
or silicone caulk in these areas.
Helpful Tip:
If installing in a vinyl siding application, you may want to place
closed cell foam and/or silicone caulk between the pet door flange and
the siding.
Train Your Pet
7A.
Bring your pet to the pet door. Temporarily tape both flaps up and try to
talk your pet into going through. If your pet will not go through the door
do not force him through the door, simply wait for your pet to go through
on his own.
Helpful Tip:
Sometimes it helps for you to be on one side of the door and your pet
on the other. You may try persuading your pet through the door using a small piece of
food or a treat.
Step 6
6A
6B
6C
Step 7
7A
