www.petsafe.net 9
Install and Attach Interior
Optional Support Installation:
5A.
Optional:
Measure from the inside of outer wall to the inside of
inner wall as shown. Cut a 2X4 to the measured length, making sure
that the cut is square. Remove any debris that may be inside the wall
where the support will be located.
5B.
Optional:
Place support inside wall so that the top of support is
flush with the bottom of cut-outs. Use 2 drywall screws (supplied) or 2
wood screws (optional) to fasten the inner side of support as shown.
Check again to make sure that the support is flush with bottom of
cut-outs.
Make sure the support fits snug and that it is not too long
or too short. In either instance, damage to the wall can
occur.
5C.
Optional:
Use the 2 drywall screws (supplied) or 2 wood screws
(optional) to fasten the outer portion of the support.
If placing screws into vinyl siding it may be necessary
to drill a hole through the siding slightly larger than the
heads of the screws. This will allow the screws to tighten
flush with plywood and not buckle the vinyl siding.
5D.
Using the holes left by the drywall screws on the A side of pet door as
pilot holes, drill a ½" (13 mm) hole for the toggle bolts.
5E.
Install the toggle bolts and screw caps into the A side of the Pet
Door as shown.
5F.
Place the A side of the pet door back into the cut hole and
tighten the bolts. Be careful not to overtighten. Snap screw caps
into place.
Helpful Tip:
You may need to start the toggle bolt into the hole. Be careful
not to overtighten. Sometimes you need to hold the screw out so the toggle
is locked while you tighten the screw until the toggle is tight enough that it
will hold itself in place while you finish tightening.
Step 5
Optional
Optional
5B
5B
Optional
5C
5D
5E
5F
