6
Customer Care Center 1-800-732-2677
www.petsafe.net 7
To Insert and Remove the Batteries
Note: Do not install the batteries while the Bark
Control Collar is on your dog.
1. Loosen or remove the collar from the
Ultrasonic Bark unit.
2. Remove the screw from the back of the unit
using a small Phillips screwdriver.
3. Slide the battery tray out.
4. Install two (2), 3-volt (CR2032) batteries
positive (+) side up.
5. Slide the battery tray back in place and secure
with the screw on the back of the unit.
To Verify the Batteries are
Inserted Correctly
1. Slide the On/Off Switch to ON ( | ).
2. The LED should flash green once.
3. If the LED doesn’t flash, you may have
inserted the batteries backwards. Try taking
them out and turning them over, ensuring that the (+) side is up.
4. If the LED still does not flash, contact the Customer Care Center.
Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the Customer
Care Center or visit our website at www.petsafe.net for a list of common retailers.
Risk of explosion if battery is replaced by an incorrect type. Do not short
circuit, mix old and new batteries, dispose of in fire, or expose to water.
When batteries are stored or disposed, they must be protected from
shorting. Dispose of used batteries properly.
Battery Life
Average battery life is 1-3 months, depending on how often your dog barks. However, due to
your dog’s learning process, your first batteries may not last as long as replacement batteries.
To conserve battery life, turn off when not in use.
Function and Response Table
Function
LED Light Response
Unit is on
Green LED Light flashes once
Emitting ultrasonic tone
Red LED Light is on
Low battery condition
Red LED Light flashes 3 times every 5 seconds
1
1
2
3
2
Fit the Bark Control Collar
Important: The proper fit and placement of your Bark Control Collar is
important for effective operation.
To assure a proper fit, please follow these steps:
1. Make sure that the Bark Control Collar is turned off.
2. Start with your dog standing comfortably (
A).
3. Place the Bark Control Collar on your dog’s neck close to the
ears. Center the Ultrasonic Bark Control Collar underneath
your dog’s neck with the On/Off Switch facing upward (
B).
4. Check the tightness of the Bark Control Collar by inserting
one finger between the collar and the back of the dog’s neck
(
C). The fit should be snug but not constricting.
5. Allow your dog to wear the collar for several minutes, then
recheck the fit. Check the fit again as your dog becomes
more comfortable with the Bark Control Collar.
6. Trim the collar as follows: (
D)
a. Mark the desired length of the collar with a pen. Allow for
growth if your dog is young or grows a thick winter coat.
b. Remove the Bark Control Collar from your dog and cut
off excess.
c. Before placing the Bark Control Collar back onto your
dog, seal the edge of the cut collar by applying a flame
along the frayed edge.
The Bark Control Collar should not be worn for more than 12 hours out
of every 24-hour period. Leaving the collar on too long could lead to skin
irritation. Please refer to page 2 for additional information.
To Re-Thread the Collar
:
The slide buckle prevents the collar from becoming loose around your pet’s neck.
:
The ridges must be facing up; the collar will slip if it is not properly threaded.
A
B
C
D
Ridges
Slide Buckle
